The Halo ML56 Series offers high performance LED downlighting that sets a new
industry high point for recessed lighting with a flexible modular system of LED
Light Modules and Trims.
The ML56 Light Module System offers an astounding selection with a 600
or 900 lumen series, 80CRI or 90CRI, and four color temperatures
2700K, 3000K, 3500K, or 4000K. For added flexibility of
installation application, the ML56 Light Modules are universal voltage
120V – 277V with integral LED drivers that are dimmable at 120V
(switchable at 120V, 220V, 230V, 240V, and 277V). The ML56 lens
provides uniform illumination and wet location listing with ML56 reflector and
ML56 Light Modules are integrated LED engines that include a LED chip package,
LED driver, heat sink, and lens in a modular design that allows interchangeable
use with ML56 5” and 6” LED trims.
This ML56 LED Module can be used with either 5 inch or 6 inch housing.
Please refer to the following table for complete light fixture.
For a complete Recessed Lighting Fixture, customer need to purchase 3
components. They are a Housing, an LED Module and a Trim.
See table below for more information.
Halo ML56 LED System Installation Instructions:
|Retrofit Adapter Connection (Only for Recessed Housing
with Standard Base)
|1. Insert orange LED
connector into orange
socket in the module.
|2. Slide connector cap
down over the LED
|3. Twist cap clockwise
|Light Module and Trim Assembly
|1. Locate the small post on
LED light module and the
slot on the trim.
|2. Align post on LED light
module with the slot on
the trim and place light
module onto trim.
|3. Rotate the three side clips
into place to secure the trim
to the LED light module.
Ensure all three clips are