UL LISTED INSTALLATION INSTRUCTIONS
IMPORTANT: Turn off power before installing or removing connector.
Product to be used in accordance with local and national codes.
1. Strip conductors 5/16”.
2. Insert conductor into wire port, fully seating conductor into port.
3. Tighten set screws to the torque indicated below, based on conductor size and
indicated. 10 in-lb #12 solid aluminum
15 in-lb #10 solid aluminum
15 in-lb all solid and stranded copper conductors
Do not over torque.
4. Once all conductors are installed, close lid taking care to verify latch is
Typical installation of a copper pigtail
Note: AL= Aluminum, CU= Copper. Also note that the ‘power out’ is optional
and not always applicable, depending on how your wiring is set up.