Lutron GRX-3103-T-MS Grafik Eye 3000 Series 3-Zone Preset Dimming Control Unit, Translucent Black Cover, Mocha Stone Base

• Lutron GRX-3103 Grafik Eye 3-Zone Control Unit 1500 Total WATTS/VA @120V
• Provides pushbutton recall of four preset lighting scenes, plus Off.
• Allows setup of lighting scenes using buttons on the Control Unit.
• Provides lockout options to prevent accidental changes.
• Includes built-in infrared receiver for operation with an optional remote control.
• Controls the following lighting sources with a smooth, continuous Square Law dimming curve
  • Incandescent, Tungsten, Magnetic Low Volt Transformer, Electronic Low Volt Transformer
  • Lutron Tu-Wire® Electronic Fluorescent Dimming Ballast
  • Neon and Cold Cathode
  • Lutron Electronic Fluorescent Dimming Ballast
• 4 preset lighting scenes and off are accessible from the Control Unit front panel.
• 12 additional scenes are stored in the Control Unit.
• Light levels fade smoothly between scenes. Fade time can be set differently for each scene, between 0-59 sec. or 1-60 min. Fade time from Off is capped at 5 sec.
• Meets IEC801-2.Tested to withstand 15kV electrostatic discharge without damage/memory loss
• Lightning Strike Protection: Meets ANSI/IEEE standard 62.41-1980. Can withstand voltage surges of up to 6000V and current surges of up to 3000A.
• Compensates in real time for incoming line voltage variations: No visible flicker with +/-2% change in RMS voltage/cycle and +/-2% Hz change in frequency/second.
• 10-year power failure memory automatically restores lighting to levels prior to power interruption.
• Faceplate snaps on with no visible means of attachment.
• Low-voltage type Class 2 (PELV) wiring connects Control Units, Wallstations & Control Interfaces.
• Up to 8 Control Units may be linked to control up to 48 zones.
• Up to 16 total Wallstations and Control Interfaces may be added for a total of 24 control points.
• 3 Gangs Wallbox Size. Mount in standard multiple gang wallbox, 3.5" deep recommended.
• For more specifications, dimensions and mounting, click here - PDF
• Note: Picture may not display true color/finish. Please refer to the item description for more info.

Lutron Grafik Eye 3000 System Overview The diagram on the right provides an overview of the components that constitute the GRAFIK Eye 3000 system, as well as compatible Lutron products. Please click on the diagram to find a complete list of components with more details.

GRAFIK Eye 3000 System Wiring This diagram illustrates basic system wiring for GRAFIK Eye 3000 Series Control Units. Note: For wiring multiple Control Units, Interfaces, and Accessory Controls, system wiring should be: Low Voltage Class 2 (PELV) 4-wire daisy chain of two No. 18 (1 .0mm 2) twisted pairs (4 wires); two Belden 9740, or one Liberty LU02PSH18EX-GRN.

Power Booster and Interface Wiring For GRAFIK Eye 3000 Series controls only. Lutron Power Boosters can be added to increase zone capacities. Note: For 120V, if it uses Lutron HP2 or HP4 or HP6, Power Interfaces such as GRX-FDBI and GRX-ELVI are NOT required.

For more Lutron Grafik Eye Lighting Controls, Click on the pictures below