Dimmer		Accessory Dimmer

Use a RadioRA Dimmer to replace one control point for lights.  Use RadioRA Accessory Dimmers at any additional control points.

• Install RadioRA Dimmers in place of standard switches
• Fine-tune the light intensity and turn lights on and off from RadioRA Master Controls
• Green indicator lights glow softly as nightlight when room light is off
• Bring lights on to full intensity by quickly tapping the dimmer twice
• Fade lights off over a 10-second period by pressing and holding the dimmer
• Use with Lutron Claro or Satin Colors screwless wallplates, sold separately

RadioRA Dimmer for Incandescent and Magnetic Low-Voltage Lighting

• Control up to 1000W/VA* of incandescent and/or magnetic low-voltage lighting from up to 10 locations
• For loads up to 600W/VA* (minimum 50W/VA):  Model # RA-6D-**
• For loads up to 1000W/VA* (minimum 50W/100VA):  Model # RA-10D-***

*   Derating required in multi-gang installations. For higher wattage loads, see the dimmer with neutral below

**  RA-6D- can be used in place of RA-600L-, RA-600LM-, RALV-600L-, and RALV-600LM-

*** RA-10D- can be used in place of RA-1000L-, RA-1000LM-, RALV-1000L-, and RALV-1000LM-

RadioRA Dimmer for Electronic Low-Voltage Lighting

• Controls up to 500W* of electronic low-voltage and/or incandescent lighting from up to 10 locations
• Minimum load is 40W
• Requires neutral wire connection
• Model # RA-5NE-**

*   Derating required in multi-gang installations. For higher wattage loads, see the dimmer with neutral below

**  RA-5NE- can be used in place of RAELV-500L- and RAELV-500LM-

RadioRA Dimmer with Neutral for Incandescent and Magnetic Low-Voltage Lighting or Power Boosters and Interfaces

• Control power boosters and interfaces or up to 600W/VA* of incandescent and/or magnetic low-voltage lighting from up to 10 locations
• Minimum load is 10W/VA
• Requires neutral wire connection
• For incandescent and/or magnetic low-voltage lighting loads up to 2000W/VA, use with Power Booster (Model # NGRX-PB-WH)
• For electronic low-voltage lighting loads up to 1000W, use with Electronic Low-Voltage Interface (Model # ELVI-1000)
• For fluorescent lighting loads (except Tu-Wire), use with Fluorescent Dimming Ballast Interface (Model # GRX-FDBI-16A-120) and Electronic Fluorescent Dimming Ballasts (see Ballasts)
• Model # RA-6ND-**

*   Derating required in multi-gang installations. For higher wattage loads, use a power booster or interface

**  RA-6ND- can be used in place of RAN-600LM-

RadioRA Dimmer for Tu-Wire® Fluorescent Lighting (single-location only)

• Controls up to 5A of fluorescent lighting from one location when used with Lutron Tu-Wire Fluorescent Dimming Ballasts
• Requires neutral wire connection
• Single-location only. May not be used with accessory dimmers for multi-location installations
• Model # RAN-FTU-5A-"color"-CPN1550

RadioRA Accessory Dimmer

• Use with any RadioRA dimmer* to control lighting from up to 9 additional locations
• Model # RA-AD-

*   except Tu-Wire, which is single-location only

Switchh		Accessory Switch

Use a RadioRA Switch to replace one control point for lights.  Use RadioRA Accessory Switches at any additional control points.

• Install RadioRA Switches in place of standard switches
• Each RadioRA Switch controls one zone, or area, of light
• Tap switch to turn lights on and off
• Use with Lutron Claro screwless wallplates, sold separately

RadioRA Switch

• Controls up to 8A* of incandescent, fluorescent, magnetic low-voltage, electronic low-voltage, and high-intensity discharge lighting loads from up to 10 locations
• Requires neutral wire connection
• Model # RA-8ANS-**

*   Derating required in multi-gang installations. For higher wattage loads, see the dimmer with neutral below

**  RA-8ANS- can be used in place of RAS-8L- and RAS-8LM-

RadioRA Accessory Switch

• Use with any RadioRA Multi-Location Switch to control lighting from up to 9 additional locations
• Model # RA-AS- 

• Labels are provided to help identify each button's purpose
• Allows selection of preset lighting scenes and monitoring of lights
• Available in 6 different button configurations so that you may choose what is best for you
• Orange indicator lights provide feedback when button is pressed
• Model #:

  RAMC-5W-		(5-button)		RAMC-5W-RL-		(5-button with raise/lower)
  RAMC-10W-		(10-button)		RAMC-10W-RL-		(10-button with raise/lower)
  RAMC-15W-		(15-button)		RAMC-15W-RL-		(15-button with raise/lower)

• Labels are provided to help identify each button's purpose
• Allow selection of preset lighting scenes and monitoring of lights
• Available in 6 different button configurations so that you may choose what is best for you
• Orange indicator lights provide feedback when button is pressed
• Model #:

  RAMC-5T-	(5-button)		RAMC-5T-RL-	(5-button with raise/lower)
  RAMC-10T-	(10-button)		RAMC-10T-RL-	(10-button with raise/lower)
  RAMC-15T-	(15 button)		RAMC-15T-RL-	(15-button with raise/lower)

• Labels are provided to help identify each button's purpose
• Allow selection of preset lighting scenes and monitoring of lights
• Available with or without raise and lower buttons
• Provides portable control of lights throughout the home
• Runs on 2 "AA" batteries to allow convenient portable control
• Orange indicator lights provide feedback when button is pressed
• Model #:

  RAMC-10C- (10-button)

  RAMC-10C-RL- (10-button with raise/lower)

• May serve as the main RF signal repeater in a system
• Bridges two RadioRA systems as the main repeater in both, allowing up to 64 dimmers/switches and 24 master controls/interfaces to be installed in a single home
• Provides a powerful, built-in astronomical timeclock that simulates daily routines with the "Away" mode, giving the appearance that someone is home
• Allows three contact closure inputs to activate two fully-programmable scenes plus a special security scene
• Supports 17 whole-home scenes (15 rooms/scenes plus "ALL ON" and "ALL OFF"), which can be acessed via any button on a master control or via the RS-232 connection
• See Design and Compatibility Considerations for detailed information on Chronos' compatibility with older RadioRA devices and design considerations when bridging systems
• Model # RA-SBT-CHR

• Required for system setup and diagnostics of RF communications
• Ensures error-free communication between system components
• Re-sends every signal sent through the system and eliminates cross-talk with neighboring RadioRA systems
• Model #:  RA-REP-WH

• Allows GRAFIK Eye Preset Lighting Controls to be used as local lighting controls in conjunction with RadioRA Dimmers and Switches
• Provides direct control of a GRAFIK Eye lighting control through RadioRA
• Each interface counts as one control toward the RadioRA system maximum of 32 local controls
• Model # RA-GRXI-WH

• Provides control of home lighting from the car--turn lights on as you arrive, and off as you leave
• Provides control of garage doors and gates
• Clips conveniently to your car's sun visor
• Use with the Multi-Function Entry Master Control (RAMC-MFE-)
• Model # RA-VCTX-

• Can be used with RadioRA Car Visor Control Transmitters
• Provides control of garage doors and gates
• Inputs allow any class 2 input device to control the lights, such as security systems, motion sensors, and timeclocks
• Model # RAMC-MFE-