||General purpose recessed downlight housing for low to medium height ceilings
for residential and light commercial applications. A variety of trims, compatible styles and
finishes are available to achieve the proper décor and illumination.
|| Pre-wired housing adjusts up to a 1 1/2”ceiling thickness. Integral thermal
protector to guard against improper lamping and installation. Housing provides an
adjustable socket plate which allows for use of different lamp types. Trim is secured with
torsion wing springs/standard coil springs.
||Housing suitable for new construction installations only, supplied with (2)24''
adjustable hanger bars with 90 degrees repositioning ability. Hanger bars equipped with
(nail-less installation) 3/4'' serrated barbed studs and with captive nails, for faster and easier
secure mounting in wood joists. Set-screws lock into position and prevent shifting after
installation. Earthquake structural cable compatible for drop panel ceiling or any other
mounting that requires direct support from structural ceilings. Housing for use in 2/12 to
6/12 pitch sloped ceilings.
||16 gauge pre-wired galvanized steel Junction Box, 32 cubic-inch for a
maximum of (8) #12 AWG wires. Furnished with (7) 3/4" and (4) Romex knock-outs. Strain
clamps to install or remove covers for easy access and ground wire. Equipped with safety
standard fitting for flex-conduit.
|| Airtight option is designed to restrict air flow from room into plenums in compliance
to the WSEC - Washington State Energy Code, (Less than 2.0 CFM -Cubic Feet per
Minute). Complies to Title24 air flow requirements (Air-tight).
||IC rated housing rated for direct contact with low to medium density
loosefill blown and rolled insulation. For use with high density loosefill blown insulation,
reduce rated lamp wattage accordingly (roughly %15-%20).
||UL/CUL listed for through-branch wiring (8) No.12 AWG 90°C and suitable
for damp locations. NYC approved: Calendar #41937.