"Hot One "  electric heater  : Great for garages and shops
 

Features and Benefits :

• Manual reset thermal protection

• Commercial grade high temperature manual reset with 25 amp rating at 240 Volt

• High mass, tubular element for long life

• Fan delay eliminates cold draft on startup and disperses residual heat on shutdown

• Built-in thermostat

• High/Low switch for temperature control

• Fan only control for cool air circulation

• Fan only control for cool air circulation

• Portable

• 6 foot cord (with polarized plug) for 240V use

• Bracket for wall mount or floor stand use

• 5 Year Warranty

General Information:
The Hot One 240 Volt portable heater is designed with the same rugged construction as Cadet's commercial unit heater line. It provides warmth for large areas that are often difficult to heat, like garages and workshops. The fan delay mechanism, standard on all units, allows the element to heat before blowing air, thereby eliminating cold startups. It also delays the shutdown of the fan after the element turns off to disperse residual heat. The Hot One comes factory equipped with a bracket for either wall mount or floor stand use (non-marking rubber pads are included on the mounting bracket). The area must be equipped with an accessible 240 Volt receptacle.


Architectural  Information:
Portable fan unit heater shall be UL Listed and rated at 240V. External cabinet shall be constructed of 20 gauge high quality steel and shall be finished with a baked on powder coat paint. Fan shall be aluminum blade axial flow type, and mounted directly to the motor shaft. Motor shall be shaded pole and industrial rated. Heating elements shall be sealed in magnesium powder and protected by metal sheathing and aluminum fins. Heater shall be equipped with manual reset thermal cut out for over temperature protection. Fan motor circuits shall be thermostatically controlled with fan delay.

Technical Information:
The Hot One 240 Volt heater is available in 4,000 watts (2,667 low setting) or 5,000 watts (3,333 low setting). It also includes a fan switch for air circulation without heat. A double pole thermostat is built into every unit. UL requires a 3' minimum clearance from front, 6" from back and top, and 12" from sides. Important: There are two different receptacle configurations shown below