The Com-PakTM Twin Plus : The economical choice
for larger areas
Features and Benefits :
-
Primary and Secondary Thermal
Safeguards
-
Commercial grade high temperature
manual reset with 25 amp rating at 240 Volt
-
Over temperature one-time thermal
device
-
Nichrome coil element for quick heat
-
Powder coat paint process eliminates
sharp metal edges
-
wall can designed for ease of
installation
-
2 Year Warranty
General Information:
The Com-Pak Twin Plus is the ideal choice for heating large areas
such as an open foyer with a single heater. Twin heaters connected behind a
single grill provide all the benefits of The Com-Pak Plus. Cadet recommends
a wall-mounted thermostat for optimum performance, or you may prefer the
convenience of an optional built-in thermostat.
Architectural Information:
Fan forced electric air heaters shall be UL Listed, factory rated
at 208V or dual field rated from 208V to 240V. A painted 20 gauge wall
mounting can with four knockouts and 79 cubic inch wiring compartment shall
be provided with each complete heater. Each complete heater shall be of
unitized construction and attach to the wall can with two screws and shall
be self-contained and completely separate from the wall mounting can. The
elements and blowers shall be of unitized construction and attach to wall
can with a single screw. Two elements shall be of nichrome type wrapped on
mica insulators with two oversized 25 amp at 240V high temperature manual
reset limit switches and two over temperature thermal backups. Two
independent two-stage centrifugal blowers shall be driven by impedance
protected motors. The motors shall be totally isolated from the heating
chamber. Metal grill shall be of one piece, 20 gauge construction and
finished with a powder coat paint system.
Technical Information:
Model may be ordered with or
without built-in thermostat. For optimum comfort use a Cadet electronic
thermostat or a dual diaphragm thermostat. Single pole and double pole field
mount thermostat kits available. Fan heaters and thermostats work best when
installed on an inside wall. UL requires heater to be placed a minimum
distance of 6" from adjacent surfaces and 4.5" from the floor. Manufacturer
recommends installation 12" from all surfaces. A 3' (91.44cm) minimum
clearance is recommended for furniture or other objects placed directly in
front of heater.
NOTE: Manufacturer recommends installing heater assembly after walls are
finished. However, if installation is necessary before walls are finished,
use the paint mask provided. Heater must be cleaned every six months
minimum.
Rough In Dimensions:
14.5"W x 11.5"H x 4"D
Wall Can Dimensions:
14.75"W x 10.25"H x 4"D
Grill Dimensions:
16.25"W x 12"H
Ordering Information:
Suffix "T" in model number denotes built-in thermostat. Model numbers
without a "T" require a thermostat. Recommended for elevations under 7500
feet.
